5. BASE SPECIFICATIONS PARAMETERS
II - 59
# Items Details Setting range (unit)
aux10
(bit4)
S command
during
constant
surface
speed
Specify whether to output a strobe signal when the S
command is issued in constant surface speed mode.
0: Output no strobe signal in constant surface
speed mode.
1: Output strobe signals in constant surface speed
mode.
0/1
aux10
(bit5)
Arbitrary
allocation of
dog signal
Specify whether to enable the arbitrary allocation
parameter for the origin dog and H/W OT.
0: Disable arbitrary allocation. (Fixed device)
1: Enable arbitrary allocation. (Device specified by
the parameter)
0/1
aux10
(bit6)
Setup and
display unit
Specify the unit to be used as the setup/display unit or
handle feed unit, the command unit or internal unit.
The machining program variables (system variables
for coordinate system) are changed simultaneously.
0: Internal unit
1: Unit specified by command
Note 1: This parameter is valid only in initial millimeter
mode (0 is set in 14041 I_inch). The internal
unit is always used in initial inch mode (1 is set
in 14041 I_inch).
Note 2: This parameter is validated immediately after it
is set.
Note 3: If addition setting is performed for tool and
workpiece offset data with the command unit
being inch and internal unit being mm, an
error may be generated.
Note 4: The internal data is an internal unit
determined with #1041 I_inch.
Note 5: This parameter is not related to the PLC axis.
Related parameter: #1152 I_G20 (Initial command
unit)
0/1
aux10
(bit7)
Shorten JOG
stop time
Specify whether to shorten the JOG stop time.
0: Do not shorten the JOG stop time. (Same as
before)
1: Shorten the JOG stop time.
0/1
