The following illustration shows the internal routing and connector for the USB/video
cable.
Note: The USB cable is routed under the video cable and then both the USB and
video cables are routed under the cable retention tab and the top cover latch
receptacle.
1 Top cover latch receptacle
2 Cable retention tab
3 Video cable
4 USB cable
Removing and installing the microprocessor 2 air baffle
To remove and install the microprocessor 2 air baffle, complete the steps in this
section.
Removing the microprocessor 2 air baffle
To remove the microprocessor 2 air baffle, complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables, if necessary; then, remove the cover (see “Removing and
replacing the cover” on page 43).
3. Lift the air baffle 2 up, making sure that the tab 1 comes out of the hole 3
on the side of the power-supply cage; then, remove it from the server and set it
aside.
Attention: For proper cooling and airflow, replace the air baffle before you
turn on the server. Operating the server with the air baffle removed might
damage server components.
Chapter 5. Installing optional devices and replacing customer replaceable units 47
