58
Diagnostic Messages cont...
Sensors are out of balance. If alternating with spa
temperature, it may just be a temporary condition. If
flashing by itself, spa is shut down.
If the problem persists, contact
your dealer or service organization.
A significant difference between temperature sensors
has been detected. This could indicate a flow problem.
Check water level in spa. Refill if necessary. If the
water level is okay, make sure the pumps have been
primed. If problem persists, contact your dealer or
Persistent low flow problems. (Displays on the fifth
occurrence of “ ” message within 24 hours.) Heater
is shut down, but other spa functions continue to run
Follow action required for “ ” message. Heating
capability of the spa will not reset automatically; you may
press any button to reset.
Possible inadequate water, poor flow, or air bubbles in
detected in the heater. Spa is shut down for 15 minutes.
Inadequate water detected in heater.
Check water level in spa. Refill if necessary. If water level
is okay, make sure the pumps have been primed. Press
any button to reset, or this message will automatically
reset within 15 minutes. If problem persists, contact your
dealer or service organization.
Check water level in spa. Refill if necessary. If water level is
okay, make sure the pumps have been primed. Press any
button to reset, or this message will automatically reset within
15 minutes. If problem persists, contact your dealer or
service organization.
