Zenoah PSZ2401, PSZ2401-CA Pole Saw User Manual


 
42
Every Every Every
25 50 100
System/compornent Procedure Before hours hours hours note
use after after after
fuel leaks, fuel spillage wipe out
fuel tank, air filter, fuel filter inspect/clean ✔✔ replace, if necessary
see ADJUSTING replace carburetor
idle adjusting screw
IDLING SPEED (p.40) if necessary
clean and readjust GAP: .025in(0.6~0.7 mm)
spark plug
electrode gap replace, if necessary
cylinder fins, intake air cooling vent clean
muffler, spark arrester, clean,
cylinder exhaust port remove piled up carbon
throttle lever, ignition switch check operation
gear case grease
screws/nuts/bolts tighten/replace ✔✔not adjusting screws
oiling port clean
guide bar clean
sprocket inspect/replace
saw chain inspect/replace
ENGINE
SHAFT
CUTTING UNIT
MAINTENANCE CHART
Maintenance, replacement, or repair of the emission control
device and systems may be performed by any non-road engine
repair establishment or individual.
9. Maintenance
English