Filter
Top Products
24
A standard package contains the items as shown
below. (SE5)
(1) Guide bar
(2) Saw chain
(3) Gear case
(4) Sprocket
(5) Chain tension adjust screw
(6) Nut
(7) Chain tensioner nut
(8) Chain cover
Install the guide bar and the saw chain on the gear
case as follows.
The saw chain has very sharp edges. Use
protective gloves for safety.
1. Loosen a nut and remove the chain cover.
2. Mount the guide bar then fit the saw chain around
the bar and sprocket.(SE6)
Pay attention to the correct direction of the saw
chain
3. Fit the chain tensioner nut into the lower hole of the
guide bar, then install the chain cover, and fasten
the mounting nut to finger tightness. (SE6)(SE7)
(1) Hole
(2) Moving direction
(3) Chain tensioner nut
4. Adjust the chain tension by turning the tensioner
screw until the tie straps just touch the bottom side
of the bar rail. (SE8)
(1) Chain tension adjusting screw
(a) Loosen
(b)Tighten
WARNING
WARNING
SE7
SE8
SE6
6. Set up
English
SE5