Filter
Top Products
28
6. Set up (EX-HE only)
English
EX-HE
SE3
EX-HE
SE4
tighten the blade mounting bolt. (SE3)
(1) Blade mounting bolt (Left-handed)
(2) Cutter holder (B)
(3) Blade
(4) Bar
(5) Cutter holder (A)
4. Split the bracket and install the wheel assembly to
the shaft tube and clamp at a position best for your
job. (SE4)
(1) Bracket
6. Set up (EX-RMS only)
English
SE1
■ SWEEPER ASSEMBLY (SE1)
1. Push one of the drum axles onto either of the two
gearcase output shafts. If necessary, rotate the drum
axle until the clevis pin hole in the axle aligns with
the matching hole in the gearcase output shaft.
2. Use a clevis pin and hitch pin to secure the drum
axel to the shaft.
3. Slide the recessed end of a sweeper drum assembly
over the assembled axle, and then push the drum
down the axel until it bottoms at the clevis pin.
(1) Clevis Pin (2) Hitch Pin
(3) Cotter Pin (4) Drum Axle
(5) Drum Assembly
The two drum assemblies are identical, but each drum
must be installed with its recessed end facing toward
the gearcase.
4. Use a cotter pin to secure the drum assembly on the
axle (see inset) . The cotter pin is designed to fit
tightly against the outboard end of the drum, so you
may need to compress the drum face slightly during
installation.
5. Repeat Steps 1-4 to install the remaining axle and
drum assembly.
IMPORTANT