Filter
Top Products
51
13. Changing the Oil Filter
1. Drain the engine oil in following the procedure
in the section, Engine Oil/ Change Engine Oil.
2. Disassemble the oil filter. If necessary, use a
filter remover.
3. Partially fill the new filter with oil.
4. Wipe new, clean engine oil onto the seal for
the new filter.
5. Mount the filter by hand with + 3/4 turn.
6. Run the engine warm, then check that there
are no leaks around the oil filter seal.
7. Check the oil level in the engine, top off
if necessary.
LUBRICATION
12. Belt Adjuster, Hydraulic Pumps
Lubricate using a grease gun, one zerk, until the
grease squeezes out.
Use only good quality lithium based grease.
Grease from well-known brand names
(petrochemical companies, etc.) usually maintains
a good quality.
IMPORTANT INFORMATION
Be careful and remove excess lubricant so
that is does not come into contact with belts
or belt pulley drive surfaces.
Lubricating the belt adjuster
BAM-24-2
Changing the oil filter
BAM--23