Filter
Top Products
11
1. Engine must kill if blades are engaged without
O.P. levers held down.
2. Engine must kill if the thumb latches are un-
locked without holding O.P. levers down.
3. Engine must not start unless the blades are
disengaged and the drive levers are locked in
the thumb latches.
4. Do not operate the mower if the interlock safety
system allows operation or starting in any un-
safe condition.
SET-UP
HANDLE HEIGHT ADJUSTMENT
The height of the handles is adjustable to two po-
sitions to accommodate different height operators.
The handles are preset from the factory in the high-
est position. To adjust the handles to the lower
position, remove the top bolt on each side of the
handle where it is bolted to the tank support. Tilt
the handles down until the next set of holes line
up. Reinstall the bolts and nuts and tighten. Check
that the bottom bolts are tight as well. Reverse the
steps to raise the handles to the higher position.
NOTE: The motion control adjustments will need
to be reset after changing the height of the handles.
See the Adjustment section on page 9.
FIGURE 8
REMOVE