Filter
Top Products
The ISC-S Cable
975-0059-01-01 Rev A 1–5
The ISC-S Cable
Required accessory
cable
Stacking two identical inverters requires the use of the Inverter Stacking Control –
Series Cable (ISC-S cable). The ISC-S cable is a special cable specifically
designed for series-stacking two identical inverters. It consists of one 36-inch
stacking control cable with two 25-pin D connectors. It connects to the “Stacking
Ports” on the respective inverters and allows the AC output of two (identical)
inverters to provide both 120 and 240 Vac, 60 Hz.
CAUTION: Damage to Equipment
Do not use a standard computer cable in place of the ISC-S cable cable. This ISC-
S cable is custom made for Xantrex to allow series-stacking with the SW Plus
Inverter/charger. Look for the label as shown in Figure 1-3 to properly identify the
cable.
Use of any other cable may damage your inverters and will not be covered by
Warranty/ Repair.
Figure 1-3
Inverter Stacking Control – Series Cable (ISC-S cable)
Xantrex ISC-S Cable
CAUTION: This cable is designed
for series stacking of the SW,
SW Plus, or PS inverters only.
Use of any other cable may damage
your inverter and void it’s warranty.