Filter
Top Products
30 Assembly
MAN0765 (12/5/2008)
ASSEMBLY INSTRUCTIONS
DEALER SET-UP INSTRUCTIONS
The mower is shipped mostly assembled but requires
dealer set-up. The Woods dealer should deliver the
mower to the owner completely assembled, lubricated,
and adjusted for normal conditions.
Recommended torque values for hardware are located
on page 50.
Complete check lists on page 33 when assembly is
complete.
Keep hands and body away from pressurized
lines. Use paper or cardboard, not hands or other
body parts to check for leaks. Wear safety goggles.
Hydraulic fluid under pressure can easily penetrate
skin and will cause serious injury or death.
Make sure that all operating and service person-
nel know that if hydraulic fluid penetrates skin, it
must be surgically removed as soon as possible by
a doctor familiar with this form of injury or gan-
grene, serious injury, or death will result. CON-
TACT A PHYSICIAN IMMEDIATELY IF FLUID
ENTERS SKIN OR EYES. DO NOT DELAY.
Make sure spring-activated locking pin or collar
slides freely and is seated firmly in tractor PTO
spline groove.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
Remove Shipping Straps
1. Remove CV drive from rear wing frame.
2. Attach drive to splitter gearbox. Position CV joint
towards the tractor. See page 36 for orientation.
3. Remove shipping straps from front and rear of right
and left wing decks.
4. Remove parking jack from storage position on left
wing.
5. Attach parking jack to trailer tongue frame.
6. Remove wood block from hitch.
Attach Hydraulic Hoses
Air in hydraulic systems can cause erratic oper-
ation and allows loads or equipment components
to drop unexpectedly. When connecting equipment
or hoses or performing any hydraulic maintenance,
purge any air in hydraulic system by operating all
hydraulic functions several times. Do this before
putting into service or allowing anyone to
approach the equipment.
Attach the mower hydraulic hose to the tractor port.
Hydraulic quick coupler is not supplied.
NOTE: The mower hydraulic system should have been
filled at the factory. Always assume it is empty. Fully
purge air and fill the hydraulic system by raising and
lowering wings several times while hooked to a tractor
hydraulic supply. Keep all personnel away while raising
and lowering.
OPTIONAL EQUIPMENT
Chain Shielding Installation
Full chain shielding must be installed when
operating in populated areas or other areas where
thrown objects could injure people or damage
property.
• If this machine is not equipped with full chain
shielding, operation must be stopped when any-
one comes within 300 feet (92 m).
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition.
It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
CAUTION