Filter
Top Products
Owner Service 23
MAN0765 (12/5/2008)
TROUBLESHOOTING
BELT CONDITIONS
* Check belt for damage by laying it flat on the floor. A belt that does not lie flat (has humps or twists, indicating broken
or stretched cords) must be replaced.
PROBLEM POSSIBLE CAUSE SOLUTION
Belt slippage Mower overloading; material too
tall or heavy
Reduce tractor ground speed but
maintain full PTO rpm.
Cut material twice, one high pass and
then mow at desired height.
Cut 90 degrees to first pass.
Oil on belt from over-lubrication Be careful not to over-lubricate. Clean
lubricant from belt and pulleys with
clean rag.
Replace oil-soaked belt.
Belt hung up or rubbing Check belt position in pulleys and
idlers.
Check belt for free travel in pulleys.
Check under mower and around
blade spindle shaft for wire, rags, or
other foreign material.
Clean all material from under mower.
Frayed edges on belt cover Belt misaligned Re-align belt. Be sure belt does not
rub any other part while running.
Pulley misaligned Inspect to ensure belt is running in
center of backside idler.
Shim idler as necessary to align.
Belt rollover Pulley misaligned Re-align.
Damaged belt Replace belt*.
Foreign object in pulley groove Inspect all pulley grooves for rust,
paint, or weld spots and remove.
Worn pulley groove Replace pulley.
Damaged belt Rollover, high shock loads or
installation damaged
Replace belt*.
Belt breakage High shock loads Avoid abusive mowing.
Avoid hitting the ground or large
obstructions.
Belt came off drive Check pulleys for foreign material in
grooves.
Avoid hitting solid objects or ground.