Filter
Top Products
Installation 5
MAN0472 (9/23/2005)
BACKHOE 3-POINT MOUNT INSTALLATION
TRACTOR PREPARATION
NOTE: For installing this 3-point mounting kit, refer-
ence to right, left, forward and rearward directions are
determined from the operator’s position in the back-
hoe seat.
NOTE: Leave all hardware loose until mounting kit
has been fit up.
1. Refer to the WOODS BH70X/BH80X Backhoe
Operator’s Manual for backhoe assembly instruc-
tions.
2. Remove the tractor top link and top link storage
bracket, if equipped.
* Operator’s seat must be located in the lowest and
most forward position to obtain 40" minimum radius.
Figure 1. Seat Clearance
Attach Rear Brackets to Backhoe
Leave hardware loose until backhoe is attached to
tractor or otherwise specified in the instructions.
1. Attach rear brackets (4 & 5) to main frame using
bolts (16) and hardened flat washers (15). Torque
hardware to 297 lbs-ft.
2. Attach mounting pins (13) to mounting brackets
using desired hole.
3. Secure using four (two per mounting pin) Nord
lock washers (6) and hex nut supplied with the
mounting pin. Do not use split lock washer sup-
plied with hitch pin.
4. Torque to 474 lbs-ft.
4. 1012534 Right rear bracket
5. 1012535 Left rear bracket
6. 1012567 M22 Nord lock washer
13. 33661 Category 1 Mounting pin
15. 57798 5/8 Hardened flat washer
16. 735 3/4 NC x 2 HHCS GR5
Figure 2. Rear Bracket Installation
3-Pt Saf-T-Lok
®
Hitch Kit
15-1/2" - 17-1/2"
TRACTOR HIGH
STRENGTH TOP
LINK PIN
40" Minimum Radius
HEAVY-DUTY
TOP LINK
CD6779-2
4
5
16
15
14
17
14 - Nut
17