Filter
Top Products
6 Assembly
MAN0115 (Rev. 3/31/2006)
Figure 8. Right Side
INSTALL HOPPER SUPPORTS
1. Remove two center 3/8 NC x 3/4 hex washer head
cap screws from both right and left side of hood
assembly. Note: Drill completely through hood
frame if not already done.
2. Attach left hopper support (2) to hood assembly.
Secure using two cap screws (6) and flange screw
(7) as shown in Figure 9.
3. Repeat steps 1 & 2 to install right support (1).
4. Install cross brace (5) between hopper supports.
Secure with cap screws (8), washer (9), and lock
nut (7). See Figure 10.
5. Install rubber bumpers (19). Secure with flange
lock nuts (13).
Figure 9. Hopper Mounting (Left Side Shown)
Figure 10. Mounting Bracket Instructions
45
49
50
36
44
4
5
42
28
39
40
41
40
48
40
4. 70067 1/4 NC x 1/2 Whiz bolt
5. 70065 1/4 NC Whiz nut
28. 70538 Latch bracket
36. 70547 Linkage latch rod
39. 70024 Clevis pin
40. 1326 Cotter pin, 1/8 x 1/2
41. 4378 5/16 Flat washer
42. 70543 Latch pivot bracket
44. 70545 Left side door latch
45. 70548 Linkage door rod
48. 64151 Clevis pin
49. 1000670 Lever stop
50. 71444 Rubber bumper
2
5
19
1
6 7
8
7
13
9
1. 74082 Right hopper support
2. 74083 Left hopper support
5. 74084 Cross brace
6. 920 3/8 NC x 1-3/4 Cap screw GR5
7. 15030 3/8 NC Flanged lock nut
8. 62153 3/8 NC Flanged screw
9. 565 Flat Washer
13. 14139 5/16 NC Flange lock nut
19. 71444 Rubber bumper
(Rev. 8/17/2007)