Filter
Top Products
4 Assembly
MAN0115 (Rev. 3/31/2006)
INSTALL CROSSMEMBERS
Figure 3. Side Panel & Front Crossmember Installed
Figure 4. Crossmember Installation
NOTE: Hopper should still be upside down. Do not
tighten hardware.
1. Install front crossmember (16) between right and
left side panels. Install crossmember with brackets
facing forward as shown in Figure 3.
2. Make sure two pivot bearings (13), (Figure 4) are
attached to the inside of front cross channel (15)
using sheet metal screws (14). Do not tighten at
this time.
3. Slide left side door trip lever (17) through opening
on left side panel, pivot bearings (13) attached to
front cross channel (15), and right side panel.
4. Secure front cross channel (15) to bottom panel
using whiz bolts (4) and whiz nuts (5). Tighten
sheet metal screws.
5. Attach right dump lever (18) to door trip lever (17),
so that both bars face forward. Secure using cap
screw (19) and lock nut (20).
6. Mount rear cross channel (12) on outside of bottom
panel using whiz bolts (4) and whiz nuts (5) as
shown. Make sure pivot hinge is at the bottom.
7. Attach left and right door hinge mounts (26, 27) to
back and side panels as shown in Figure 5. Use
whiz bolt (10) and whiz nut (5) to secure hinge
mount to back panel.
Figure 5. Right Door Hinge Mount Installation
INSTALL DOOR
NOTE: 90° bend on latch bracket faces forward.
1. Attach latch brackets (28) to bottom of door (24).
2. Place nylon bearings (23) into door hinge mounts.
3. Insert both left and right door hinges (26, 27) into
door hinge mounts.
4. Place door (24) over hinges and secure with whiz
bolt (4, 10) and whiz nut (5).
DP7A
Front Crossmember
4. 70067 1/4 NC x 1/2 Whiz bolt
5. 70065 1/4 NC Whiz nut
12. 1000679 Rear cross channel
13. 71163 Pivot bearing
14. 27610 5/16 x 3/4 Sheet metal screw
15. 1000680 Front cross channel
17. 1000677 Left side door trip lever
18. 1000678 Right dump lever
19. 3184 1/4 NC x 1-1/4 HHCS
20. 6128 1/4 NC Lock nut
26. 70536 Right door hinge
27. 70537 Left door hinge
26
4
5
5
10
4. 70067 1/4 NC x 1/2 Whiz bolt
5. 70065 1/4 NC Whiz nut
10. 70068 1/4 NC x 3/4 Whiz bolt
26. 70536 Right door hinge
(Rev. 8/17/2007)