Filter
Top Products
Assembly 31
MAN0670 (Rev. 6/27/2008)
ASSEMBLY
DEALER SET-UP INSTRUCTIONS
Assembly of this cutter is the responsibility of the
Woods dealer. It should be delivered to the owner com-
pletely assembled, lubricated, and adjusted for normal
cutting conditions.
The cutter is shipped partially assembled. Assembly
will be easier if aligned and loosely assembled before
tightening hardware. Recommended torque values for
hardware are located in the Bolt Torque Chart, page
47.
Complete Dealer Check Lists, page 34 when you
have completed the assembly.
Full chain, rubber, or steel band shielding must
be installed when operating in populated areas or
other areas where thrown objects could injure peo-
ple or damage property.
• If this machine is not equipped with full chain,
rubber, or steel band shielding, operation must
be stopped when anyone comes within 300 feet
(92 m).
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition.
It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
Make sure spring-activated locking pin or collar
slides freely and is seated firmly in tractor PTO
spline groove.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
Figure 28. Shipping Configuration
CAUTION
1. Diagonal brace
2. Tailwheel bracket
3. Tailwheel
4. Height adjustment
5. 5/8 NC x 2 HHCS
6. 5/8 NC Flange
lock nut
9. 1/2 NC x 1-1/2
HHCS
10. 1/2 NC Flange
lock nut
11. A-Frame bar
A. Diagonal brace &
Tailwheel bracket
mounting hole
B. Driveline
C. Clutch shield
2
A
B
3
4
DP1
5
6
11
1
C
10
9