Filter
Top Products
46 Assembly
MAN0390 (Rev. 4/6/2007)
1. Install a reducer bushing (15) and a restricter
swivel elbow (16) in port at base end and rod end
of cylinder (14). Position elbows to point toward
front of cutter.
NOTE: Mounted units must use a double acting
cylinder to prevent damage to tailwheels during
transport.
2. Connect hoses (17) to elbows (16).
Install Driveline
1. Coat input shaft of gearbox with a light coating of
grease.
2. Attach slip clutch on driveline (5) to input shaft of
gearbox. Tighten cap screws (37) and lock nut
(38).
3. Attach rear tether chain of driveline to driveline
shield.
Figure 42. DS120 Mounted Assembly
1. Tailwheel arm
2. Rear A-frame bar
3. Front A-frame bar
4. Lower hitch pin
5. Driveline
6. Sleeve, 3/4 x 1-1/4 x 3
7. Break link
8. Sleeve, 3/4 x 1 x 3
9. Sleeve, 5/8 x 1 x 1-1/4
10. Headless pin, 3/4 x 5
11. Headless pin, 1 x 4-1/2
12. Headless pin, 1 x 5
13. Transport lock-up
37. Cap screw,
M12 x 1.5P x 65 mm
38. Lock nut, M12 x 1.5P
39. Cap screw, 3/4 NC x 5-1/2
40. Lock nut, 3/4 NC
41. Cotter pin, 1/4 x 1-1/2
42. Klik pin, 1/4 x 1-3/4
43. Cap screw, 5/8 NC x 2-3/4
44. Flat washer, 1"
14. Hydraulic cylinder, 3 x 8
15. Reducer
16. Elbow, restricter
17. Hose, 156"
18. Ratchet
19. Sleeve, 5/8 x 1 x 13/16
30. Cap screw, 5/8 NC x 5
31. Lock nut, 5/8 NC
32. Lock nut, 1" NC
33. Cap screw, 1" NC x 12
34. Flat washer, 5/8
35. Carriage bolt, 5/8 NC x 2-1/2
36. Klik pin, 7/16 x 2