Filter
Top Products
4 Introduction
MAN0390 (Rev. 6/30/2006)
SPECIFICATIONS
DS96 DS120
Cutting Height (varies with tire selection) 2" - 15" 2" - 15"
Cutting Width 96" 120"
Overall Width 103" 127"
Tractor HP 40 - 120 40 - 120
Tractor PTO rpm 540 540
Blade Spindle 2 2
Blade Overlap 4" 4"
Number of Blades 4 4
Center Driveline with Slip Clutch Cat 4 Cat 4
Side Frame Thickness 7 ga 7 ga
Weight - Pull-Type (approximate lbs.) 1,800 1,930
Blade Speed (feet per minute) 15,900 16,700
Blade Rotation Left Spindle: CCW; Right Spindle: CW
Wheel Size 15" Rims or 21" OD Solid Tires
22" or 29" Used Aircraft Tires
Torsion Protection Slip Clutch and Flex Couplers
GENERAL INFORMATION
Some illustrations in this manual show the
equipment with safety shields removed to provide
a better view. This equipment should never be
operated with any necessary safety shielding
removed.
The purpose of this manual is to assist you in operating
and maintaining your cutter. Read it carefully. It fur-
nishes information and instructions that will help you
achieve years of dependable performance. These
instructions have been compiled from extensive field
experience and engineering data. Some information
may be general in nature due to unknown and varying
operating conditions. However, through experience
and these instructions, you should be able to develop
procedures suitable to your particular situation.
The illustrations and data used in this manual were cur-
rent at the time of printing but, due to possible inline
production changes, your machine may vary slightly in
detail. We reserve the right to redesign and change the
machines as may be necessary without notification.
Throughout this manual, references are made to right
and left directions. These are determined by standing
behind the equipment facing the direction of forward
travel. Blade rotation is clockwise (right) and counter-
clockwise (left) as viewed from the top of the cutter.