Filter
Top Products
22 Owner Service
MAN0390 (Rev. 4/6/2007)
Figure 12. Jackstand Placement and Lubrication Points
SERVICING BLADES
Removing Blades (Figure 13)
NOTICE
■ If blade pin (12) is seized in crossbar and
extreme force will be needed to remove it, support
crossbar from below to prevent gearbox damage.
Figure 13. Blade Assembly
1. Disconnect driveline from tractor PTO.
2. Open blade access cover and align crossbar (8)
with blade access hole in the cutter frame. Remove
cap screw (35), blade pin lock clip (15), keyhole
plate (14), and shims (13 & 16). Carefully drive
blade pin (12) out of crossbar.
3. Rotate crossbar (8) and repeat for opposite blade.
Installing Blades
Your dealer can supply genuine replacement
blades. Substitute blades may not meet original
equipment specifications and may be dangerous.
NOTICE
■ Crossbar rotation has counterclockwise rota-
tion on left gearbox and clockwise rotation on the
right gearbox when looking down on cutter. Be
sure to install blade cutting edge to lead in correct
rotation.
6. Rotating Drive Shield 10 hrs.
7. Side Drive Yoke (2 Places) 40 hrs.
8. Gearbox (Check Oil Level,
Lower Hole on Center Gearbox
Side Hole on Spindle Gearboxs) Daily
9. Tailwheel Spindle 20 hrs.
10. Caster Wheel Swivel 40 hrs.
1. Front U-Joint 10 hrs.
2. Mid U-Joint 10 hrs.
3. Carrier Bearing Block 40 hrs.
4. Telescoping Shaft 10 hrs.
5. Rear U-Joint 10 hrs.
8. Crossbar
9. Blade
12. Blade pin
13. Shim
14. Keyhole plate
15. Blade pin lock clip
16. Shim
35. Cap screw
CAUTION
(Rev. 10/5/2007)