Filter
Top Products
7
PN-51210 (Rev. 7/98)
A
SSEMBLY
For instructions on assembling the hydraulic feed kit, see page 20.
Do not operate this unit without the chipper chute correctly installed. Rotating
cutting blades can cause serious personal injury.
1. Remove chipper from shipping crate. Place unit on a level surface before
attempting to assemble. See torque chart for minimum tightening torque.
2. Mount the chipper chute to the frame mounting bracket using eight 3/8" x 1"
bolts and locknuts. Use three bolts on each side and two on the bottom (see
figure 1). Attach the chute directly to the hydraulic feed unit as described
above for models with factory-installed hydraulic feed.
Torque Chart
Standard minimum
tightening torque for
normal assembly
applications.
Bolts (SAE GR5)
Size Ft. Lbs.
5/16" 20
3/8" 35
1/2" 75
Screws
Size Ft. Lbs.
5/16" Set 15
Figure 1
Chipper
Frame
Chipper
Chute
Assembly
Attach Chipper Chute