8
PN-51210 (Rev. 7/98)
A
SSEMBLY
1. Slide the chute extension tray over the chipper chute as shown in figure
2 after mounting the chute to the chipper frame. Make sure you position
the lip on the extension tray behind the lip on the chipper chute. Align
the five bolt holes in the chute extension tray with the bolt holes in the
hinge.
2. Insert five 3/8" x 1" carriage bolts (included in owners kit packaged with
the chipper) through the tray and the extension hinge. Secure the bolts
with washers and nuts. Secure with hairpin clips.
1. Attach the blower discharge tube to the mounting flange on the chipper
frame (see figure 3). Half of the mounting clamp is already attached to
the tube. Slide the tube into the flange and tighten the bolts to secure it.
Install the second half of the clamp to the tube and flange. Rotate the
tube 360 degrees and lock it in place with the handle to make sure it is
mounted correctly.
Figure 2
s
s
Position this lip
behind the lip on
the chipper chute
shown below.
Hold the extension
tray directly above
the chipper chute
and slide it
downward.
Extension Tray
Extension
Hinge
s
Mounting
Clamp
Mounting
Flange
Figure 3
Blower
Discharge
Tube
Hairpin
Clip
Chipper
Chute
Feed Control
Lever (Models
with hydraulic
feed only.)
Attach Chute Extension Tray
Attach Blower Discharge Tube