Filter
Top Products
English 17
ƽ
Danger
Risk of injury! Before carrying out any tasks on the machine, set the main key to "0" and remove it. Press emergency-stop button.
Troubleshooting
Fault Remedy
Appliance cannot be started Sit on the driver seat, the seat contact switch gets activated
Release emergency-stop button
Insert battery plug.
Set main switch to “1”
Check fuse F1, have it replaced by Windsor customer service if required
Check battery; charge it, if needed
Inform Windsor Customer Service.
Machine is not sweeping properly Check roller brush and side brushes for wear, replace if necessary.
Check function of bulk waste flap
Check sealing strips for wear, adjust or replace as required
Check belts of sweeping drive.
Inform Windsor Customer Service.
Dust gathers in the machine Empty waste container
Check suction fan drive belt
Check sealing cover on suction fan
Check hoses of suction blower for absence of leakness.
Check dust filter, clean or replace
Check filter case seal
Close wet/dry flap
Check sealing strips for wear, adjust or replace as required
Inform Windsor Customer Service.
Poor cleaning performance at edg-
es
Replace side brush
Check sealing strips for wear, adjust or replace as required
Inform Windsor Customer Service.
Side brush or roller brush is not be-
ing lowered
Check fuse F2, replace if required.
Inform Windsor Customer Service.
Insufficient vacuum performance Check filter case seal
Check sealing cover on suction fan
Check hoses of suction blower for absence of leakness.
Insert lamella filter correct; see Changing dust filter
Inform Windsor Customer Service.
Roller brush does not turn. Remove belts or cords from roller brush
Inform Windsor Customer Service.
Error code is displayed. Completely switch of the appliance and turn it back on.
If this error recurs, please contact the Windsor customer service department
Error code
Indicator lamp -
service
Indicator lamp -
battery charge
status indicator
Indicator lamp -
Overload of the
filter cleaning
Indicator lamp -
overlaod of the
drive motor
Indicator lamp -
Overload of the
sweep roller
Significance
yellow green/yellow/red red red red
blinking -- -- -- x Press emergency-stop button.
blinking -- -- x -- Overtemperature on the circuit board
blinking -- -- x x Battery voltage defective
blinking -- x -- -- Drive pedal error
blinking -- x -- x Line interruption, electrical consumers
blinking -- x x -- Short circuit, electrical consumers
blinking -- x x x Error while charging
blinking x -- -- -- Performance module defective
blinking x -- -- x Built-in charging device defective
blinking x -- x -- General contactor does not open
Off Not important x -- -- Overload of the filter cleaning
Off Not important -- x -- Overlaod of the drive motor
Off Not important -- -- x Overlaod of the sweep roller