Filter
Top Products
English 11
Note
Press the emergency-stop button to imme-
diately deactivate all functions and turn the
key switch to the "0" position.
To unload the machine, proceed as follows:
Î Cut plastic packing belt and remove foil.
Î Remove the elastic tape fasteners at
the stop points.
Î Four indicated floor boards of the pallet
are fastened with screws. Unscrew
these boards.
Î Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
Î Slide the four support beams included
in the packaging under the ramp.
Î Remove the wooden blocks used for ar-
resting the wheels and slide them under
the ramp.
Î Loosen immobilizing brake (see "move
sweep machine").
Î Slide the machine over the prepared
ramp from the pallet.
Î Connect battery (see section on Care
and maintenance)
Î Release emergency-stop button by
turning.
Î Set main switch to "1".
Î Press the drive direction switch and
slowly move the machine down from
the ramp.
Î Set main switch back to "0".
ƽ Danger
– Risk of injury! Before releasing the im-
mobilizing brake, the machine must be
secured to prevent it rolling away. After
releasing the emergency brake, the ap-
pliance will roll until a speed of 2.8 mph
(4.5 km/h) is reached. After that, the
electronics will brake the appliance.
– It is prohibited to release the emergen-
cy brake on an incline without using the
stopper.
Î Remove the brake level from the wheel
and put it in its position.
The immobilizing brake is thus deactivated;
the machine can now be moved.
The appliance will brake electrically while
standing still, if one of the following condi-
tions is met.
– Foot was removed from the pedal.
– Operator's seat was left for more than 1
second.
– Key switch was set to “0”.
The automatic emergency brake will only
work while the appliance is at a standstill.
Î Park the sweeper on an even surface.
Î Remove the key.
Î Check charging status of battery.
Î Check side brush.
Î Check roller brush.
Î Shake off dust filter.
Î Empty waste container.
Î Check tyre pressure.
Note
For description, see section on Care and
maintenance.
Î Pull seat adjustment lever inwards.
Î Slide seat, release lever and lock in
place.
Î Check that the seat is properly locked in
position by attempting to move it back-
wards and forwards.
– Indicator lamp glows green
Battery is charged (100...40%).
– Indicator lamp glows yellow
Battery is discharged to 40 ... 20%.
– Indicator lamp blinks red
Battery is almost discharged. The sweep-
ing mode will be shortly switched off auto-
matically.
– Indicator lamp glows red
Battery is discharged. The sweeping mode
will be terminated automatically (the
sweeping aggregates cannot be taken into
operation until the battery is charged).
Î Drive the machine directly to the charg-
ing station; avoid any steep gradients in
the process.
Î Charge battery.
ƽ Danger
Danger of accident. The immobilizing brake
must always be checked first on an even
surface before starting the machine.
Î Take the seating position.
Î Release emergency-stop button by
turning.
Î Set main switch to "1".
Î Activate the travel direction switch (for-
ward/reverse).
Î Gently depress drive pedal.
Î You must hear the brake being re-
leased. The machine must roll slightly
on a plane surface. When the pedal is
released, the brake falls in in an audible
manner. Switch off the machine and call
the aftersales service if the above-men-
tioned events do not occur.
Note
The max. load of the storage area is
44.1 lbs (20 kg).
Î Fasten the load through appropriate
fasteners at the 4 eyelets.
– The appliance has an emergency OFF
switch. If this switch is pressed, the ap-
pliance will stop abruptly and the auto-
matic emergency brake will be
activated.
– In order to restart the appliance, first un-
lock the emergency OFF switch, then
turn the key switch on and off.
1Driving
Driving to the Place of Use.
2 Sweeping with sweep roller
Roller brush is lowered. The roller brush
and the side brush will rotate.
3 Sweeping using roller brush and side
brushes
Roller brush and side brushes are low-
ered.
Note
The machine is equipped with a seat con-
tact switch When you quit the driver seat,
the machine comes to a halt after a delay of
approx. 1.5 seconds and the activated
sweep function is switched off.
Î Sit on the driver's seat.
(1) Machine without built-in battery
(2) Machine with built-in battery
Move the sweep machine
Start up
General notes
Inspection and maintenance work
Operation
Adjusting driver's seat
Check charging status of battery
Check immobilizing brake
Storage area
Emergency-stop button
Programme selection
Turning on the Machine