Filter
Top Products
35
Figure 25
14. Remove the belt from the Clutch pulley.(See Figure 25)
15. From the front of the Z-series, pull the mower deck towards you. This will release the retaining arms from the
mower deck. (See Figure 26)
Figure 26
16. Lift and hold the retaining arms up.
17. Move the mower deck toward the rear of the Tractor until the retaining arms clear the mower deck.
18. From the right side, pull the mower deck out from under the Tractor.
19. To service the blades or the under-side of the mower deck, there is a mower deck stand that folds out from
the top of the mower deck.
INSTALLING A NEW MOWER DECK BELT
1. Remove the mower deck. See REMOVING THE MOWER DECK for details.
2. Remove the old belt from the mower deck.
3. Install and route the new belt according to the routing diagram shown in MOWER DECK BELT ROUTING.
4. Install the mower deck. Refer to INSTALLING THE MOWER DECK.
Belt
Clutch
Pulley
Retaining
Arm
Retaining
Bracket