Filter
Top Products
22
SECTION 7: LUBRICATION
Use the two tables that follow for lubrication details. The first table is for Oil details and the second table is for
grease point information.
Oil Check Change Capacity Type
Engine crankcase See Engine Operator’s Manual Section
Hydraulic units 50 Hours 500 Hours 9.5 Quarts Part Number 737-0305 (10W40 motor oil)
Grease Point When to Grease Type of Grease
Caster wheels - 3 fittings (1 on each
wheel and one on middle of caster
assembly)
50 Hours Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multi-purpose lithium grease (refer to GREASE
POINT LOCATIONS on page 23 for locations)
Control Tower - 2 fittings
(Right side of tower)
50 Hours Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multi-purpose lithium grease (refer to GREASE
POINT LOCATIONS on page 23 for locations)
Lift Arms 50 Hours Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multi-purpose lithium grease (refer to GREASE
POINT LOCATIONS on page 23 for locations)
Lift Handle 50 Hours Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multi-purpose lithium grease (refer to GREASE
POINT LOCATIONS on page 23 for locations)
Idler arms 50 Hours Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multi-purpose lithium grease (refer to GREASE
POINT LOCATIONS on page 23 for locations)
Mower Deck, Spindles, Wheels 50 Hours Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multi-purpose lithium grease (refer to GREASE
POINT LOCATIONS on page 23 for locations)