Filter
Top Products
34
Figure 23
5. Release the Tension Bar.
6. Push the Tension Bar out of the bracket.
7. Lift the bar over the bracket and allow the bar to rest on the mower deck.
8. Pull the J pin out until the end of the pin is past the bracket. (See Figure 24)
Figure 24
9. Turn the J pin so that the end rests against the bracket, keeping the pin out.
10. Move the Lift handle to position 7 (all the way up).
11. Remove the Belt from the outside pulley of the mower deck by pulling and holding the belt so part of it is
outside the pulley.
12. Turn the pulley counterclockwise until the belt is completely off of the pulley.
WARNING: Exhaust and surrounding engine parts are very hot and can cause severe burns when
touched.
13. Locate the Clutch Pulley. It is located in the rear of the tractor, below the muffler. (See Figure 25)
48” and 54” Mower Decks
Wing Nut
Tension Bar
Bracket
J Pin