Filter
Top Products
-- 6 --
blower tubes. The rotating blades can cause
serious injury.
1. Insertthe tip ofa scr ewdriver into the latch
area of the vacuum inlet.
Latch
Area
Blower
Outlet
Vacuum Inlet Cover
Latch
A
rea
2. Gently tilt thehandle of thescrewdriver to-
ward the front of the unit to release the
latch while pulling up on the vacuum inlet
cove r with your other hand.
3. Hold the vacuum inlet cover open untilup-
per vacuum tube is installed.
Vacuum
Inlet
Cover
Vacuum I nlet
c
4. Align the tabs on theinside o ftheva cuum in-
let with the slots on the upper va cuum tube.
Tab
Slot
5. Push the upper vacuum tubeinto the vac-
uum inlet. T urn t he tube counterclock wise
until a click is felt to secure the tube to the
blower unit.
6. Align slantedend of low ervacuum tubeas
shown. Firmly push lower vacuum tube
into upper vacuum tube.
Slanted end of
lower vacuum tube
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
1. Remove the elbow tube and vacuum bag
by turning the knob count erclockwise to
loosen the elbow tube.
2. Remove the vacuum tubes by turning the
tubes clockw ise.
3. Close the vacuum inlet cover and make
sure it is latched closed.
4. Reinstall the blower tubes (see BLOWER
TUBE ASSEMBLY).
SHOULDER STRAP ADJUSTMENT
1. Hold the unit as shown wit h the muffler side
facing away fr om your body and clothes.
2. Pass the shoulder strap over your head
and onto your right shoulder.
3. Extendyour left arm toward the r ear ofthe
vacuum bag.
4. Adjust shoulder strap until the vacuum
bag/shoulder strap seam lies between
your thumb and index finger .
5. Make sure air flows freely from the elbow
tube into bag. If bag is kinked, the unitwill
not operate properly .