Filter
Top Products
-- 6 --
5. Placethe hooks ofthe uppervacuumtube
on the retaining posts of the unit.
6. Pivot the tube until it is secured to the
blower unit by the vacuum inlet latch.
Retaining
Post
Hook
Inlet C over
Latch
PIVOT
HOW TO CONVERT UNIT F ROM
VACUUM USE TO BLOWER USE
1. Remove the vacuum tubes by inserting
the tip of a screwdriver into the latch area
of the vacuum inlet.
2. Gently tilt handle of screwdriver toward
the back of the unit to release the latch
while pulling upon theupper vacuumtube
with your other hand.
Latch Area
3. Remove the vacuum bag.
4. Close t he vacuum inlet cover and make
sure it is latched closed.
5. Reinstall the blower tube (see BLOWER
TUBE ASSEMBLY).
SHOULDER STRAP ADJUSTMENT
1 Hold the unit as shown with t he muffler side
facing a way from your body and clothes.
2. Pass the s houlder strap over your head
and onto your right shoulder.
3. Extend your leftarmtoward therear ofthe
vacuum bag.
4. Adjust shoulder strap until the vacuum
bag/shoulder strap seam lies between
your thum b and index finger.
5. Make sure air flows f reely from the elbo w
tube intobag. If bag is kinked, the unit will
not operate properly .