Filter
Top Products
67
Maintenance Instructions
CLEANING/
CHECKING/SERVICING
Hydrostatic Transmission Cooling Fins
Keeping the cooling fins on the hydrostatic transmis-
sions clean and free of obstruction is essential to
avoid overheating the transmission fluid and short-
ening transmission life. The cooling fins should be
checked every 100 hours; and cleaned if necessary.
To clean the fins, use compressed air and/or a pres-
sure washer. The cooling fins extend all the way
around the housing -- the fins underneath need to be
clean as well as the more visible fins above. Also,
pay close attention to the area under the drive pulley.
IMPORTANT: In case an oil leak develops on the
input shaft, the cooling fan blowing dusty air and oil
on the transmission will quickly pack the cooling
fins with oily dirt. If this condition occurs, replace
the seal immediately to avoid overheating and dam-
aging the transmission. The input shaft assembly
and seal are easily replaced without removing the
transmission from the machine.
An additional procedure in maintaining transmission
cooling is to inspect the cooling fans. Replace the
fan(s) if blades are missing or damaged.
Hydrostatic Transmission Cooling Fins
CHECKING/SERVICING
Engine Cooling System - MTL
Coolant Level
Model MTL Overflow Tank
Check the coolant level in the coolant recovery tank
and maintain the coolant level between the FULL
and LOW marks on the recovery tank. When the
engine is cold, the coolant level should be at or
slightly above the LOW mark on the recovery tank.
If the coolant level is low, remove the radiator cap
and fill to the overflow port level and then fill the re-
covery tank above the LOW mark. Use a pre-mixed
50/50 solution of antifreeze (ethylene glycol) and
distilled water to fill the cooling system.
Cooling Fan
Cooling Fins
DANGER
To prevent accidental starting of the en-
gine when servicing or adjusting the ma-
chine, remove the key from the ignition
switch and disconnect the spark plug
wires.
WARNING
NEVER remove the radiator pressure cap
when the engine is hot — hot water could
spray and cause a burn if the cap is taken
off too soon.
Recovery Tank