Filter
Top Products
Assembly Instructions
27
1. Remove the pin and hairpin from each gauge
wheel. Select the required number of spacer
sleeves to remain on the bottom portion of the
gauge wheels. Refer to ADJUSTMENTS of
Rotary Broom Gauge Wheels in Maintenance
Instructions.
2. Remove the parking stands and replace them
with the gauge wheels. Place the remaining
spacer sleeve(s) over the gauge wheels on the
upper part of the stand supports, and secure the
gauge wheels with the pins and hairpins.
Optional Gauge Wheel Installation
TWO-STAGE SNOWBLOWER
Snowblower Assembly
1. Install the hand guard on the chute, with the top
section inside the chute and the bottom section
outside the chute base ring. Place two (2) 1/4 x
3/4 in. bolts through the chute and the hand
guard. Secure with a flat washer, lock washer,
and nut. Position the bolt with the head on the
outside of the chute and the nut on the inside.
Torque both bolts to 10 ft-lb. (13.6 N·m).
Install Hand Guard on Chute
2. Remove the bushing support from the chute
base lip and discard the existing bolt (refer to In-
stall Rotation Worm Assembly photo).
3. Place the plastic anti-friction insert over the
chute base (placing the nipple on the upper side
towards the center of the fan housing). Only
one position provides a perfect fit. Apply grease
on top of the insert where it will contact the
chute base.
Install Plastic Insert over Chute Base Lip
4. Insert the 1-5/16 in. (33 mm) plastic bushing in-
to the tube weldment.
Spacer
Sleeves
Pin
Hairpin
Stand
Support
Gauge
Wheel
Hand
Guard
Chute Base
Ring
Nipple
Apply Grease