Filter
Top Products
19
Checking the Status of the Clearwave
®
Device
Step 1 Be sure the device is turned off. To place the device into status mode, press
and quickly release the power button. The device will remain in status mode
for approximately 30 seconds.
Step 2 The battery life indicator displays the respective status of battery charge levels.
The display will show the number of cycles remaining on the Treatment Head.
Step 3 When 30 seconds have elapsed, the device will shut off.
Information Display Indicators
Display Mode Explanation Reference
Number Operating Time remaining on current treatment cycle See Page 18
Number Idle Number of treatment cycles remaining on head See Page 19 or 20
0 Idle Treatment Head is exhausted See Page 20
- - - Treament Head is not correctly attached See Page 20
LO Battery is low See Page 21
HP Device requires cooling See Page 22
CP Device is too cold to operate See Page 22
Treatment Head Life Indicator and Battery Life Indicator
Treatment Head Life Indicator Light
Battery Life Indicator Light
3 lights More than 75 treatments remaining More than 75% of the battery is charged
2 lights Between 75 and 25 treatments remaining 25% to 75% of the battery is charged
1 light Fewer than 25 treatments Less than 25% of the battery is charged
Flashing light Head needs to be replaced Battery needs to be charged
Instructions, Operation and Directions for Use — continued
Controls
a. Power Button
b. Head Latch Buttons
Status Indicators
c. Information Display
d. Battery Life Indicator Lights
e. Treatment Head Life Indicator Lights
f. 32 LED Lamps
b.
f.
a.
c.
d.
e.