Filter
Top Products
8 unigreen
3.2 NOISE LEVEL OF THE MACHINE
Use earmuffs to protect your ears when using the machine, below you will find the data on
the maximum noise levels during work.
Atomisers with centrifugal fan rotor (Airdrop)
ACOUSTIC POWER LEVEL emitted by the machine: 123,8 dBA in 2nd gear
ACOUSTIC POWER LEVEL AT THE OPERATOR’S POSITION emitted by the machine:
103,2 dBA in 2nd gear
Readings taken in accordance with the following standards:
Machines Directive 98/37/CE (Dir.89/392 CEDir. re-codified).
Legislative Decree D.Lgs. n°292 of the 4th of September 2002 concerning the environmental
acoustic emission of machines and equipment for use outdoors.
Legislative Decree D.Lgs. 277/91 on the subject of the protection of workers against the risks
deriving from exposure to chemical, physical and biological agents.
3.3 STANDARDS OF REFERENCE:
- MACHINES DIRECTIVE 98/37/CEE (Dir.89/392 CE Dir. re-codified).
- Directive 86/188/CEE: risks deriving from exposure to noise (implemented in Italy by
Legislative Decree D.L 277/1991)
- DPR 547/1955: Regulations for the prevention of accidents and hygiene at work.
- Legislative Decree D.Lgs. n°292 of the 4th of September 2002 concerning the
environmental acoustic emission of machines and equipment for use outdoors.
-UNI EN ISO 12100-1/Apr.2005 : Machinery safety - Fundamental concepts, general design
principles - Part 1: basic terminology, methodology
-UNI EN ISO 12100-2/Apr.2005 : Machinery safety - Fundamental concepts, general design
principles - Part 2: Technical principles
-UNI EN 294/July 1993: Machinery safety, safe distances to avoid reaching hazardous areas
with upper limbs.
-UNI EN 349/June 1994: Machinery safety, minimum spaces to prevent crushing of body
parts
-UNI EN 907/Nov.1998: Agricultural and forestry machinery - Sprayers and spreaders of
liquid fertilizers - Safety.
-UNI EN 954-1/Dec. 1998 : Machinery safety - Fundamental concepts, general design
principles
-UNI EN 982/July 1997: Machinery safety. Safety requisites relevant to systems and their
components for hydraulic and pneumatic transmissions. Hydraulics.
-UNI EN ISO 4254-1/June 2006: Agricultural machines - Safety - Part 1: General requisites
-ISO 11684/1995: Pictograms - general principles.
4 INSTRUCTIONS
To use the machine the personnel must be suitably trained on the basis of the regulations in
force on safety and hygiene at work.
THE USE OF THE MACHINE FOR PERSONS UNDER 18 YEARS OF AGE IS STRICTLY
FORBIDDEN
4.1 DESCRIPTION OF THE MACHINE
The mistblowers consist of a structural steel frame and a polyester tank reinforced with
fibreglass or high-density polyethylene. The frame is hot-galvanised. The tank is easy to
empty and this makes it possible to use the machine even on hillsides.
The pumps are generally diaphragm pumps but in some cases they are fitted with pistons.
The accessories for completing the fitting, non-drip jets and ceramic nozzles make the
UNIGREEN mistblower a highly qualified and efficient piece of equipment.
4.1.1 WORK STATIONS
The use of this machine does not envisage an operator standing constantly near the same,
the operator normally sits in the cab of the tractor.
During calibration and maintenance operations the operator will be working near the machine
at ground level (for all the calibration and maintenance operations refer to the relevant
chapters).
In some special models with controls above 1.5 metres there is a platform to make these
operations easier.
This platform must only be used with the machine stopped.
4.1.2 HAND WASHING TANKS
The mistblowers are supplied with an auxiliary hand-washing tank with clean water and a
hand tap.
This tank must always be supplied with water and the inside must be clean so you can wash
any parts of the body that come into contact with the chemical product used.
Never drink the liquid inside.
This symbol identifies the clean
water tank on the machine used
to wash your hands