Filter
Top Products
24 se c t i O n 7— se r v i c e24 se c t i O n 7— se r v i c e
cutting deck by removing the hair pin clip which secures it.
Gently slide the cutting deck (from the left side) out from
underneath the tractor.
Tires
Never exceed the maximum inflation
pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
Refer to the tire sidewall for exact tire
overinflate. Uneven tire pressure could cause the cutting deck to
mow unevenly.
Battery
!
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
If removing the battery, disconnect the
(Red) wire its terminal first, followed by the
NEGATIVE (Black) wire.
Jump Starting
Never jump start a damaged or frozen
battery. Be certain the vehicles do not touch, and
ignitions are off. Do not allow cable clamps to touch.
Connect positive ( +) cable to positive post (+) of your
Connect the other end of the cable to the (positive 2. +) post
of the jumper battery.
Connect the second cable (negative 3. –) to the other post of
the jumper battery.
Make the final connection on the engine block of the
tractor, away from the battery. Attach to a unpainted part
to assure a good connection.
If the jumper battery is installed on a
engine when jump starting your tractor.
5.
this manual.
cables, in reverse order of connection.
Charging
Batteries give off an explosive gas
while charging. Charge the battery in a well
ventilated area and keep away from an open flame
or pilot light as on a water heater, space heater,
furnace, clothes dryer or other gas appliances.
Always follow its instructions and heed its warnings.
If your tractor has not been put into use for an extended period
of time, charge the battery as follows:
If your battery charger is automatic, charge the battery until the
charger indicates that charging is complete. If the charger is not
automatic, charge for no fewer than eight hours.
Fuse
excessive amperage.
will not crank, first check to be certain that the fuse has not
blown. It can be found at the rear of the unit, underneath the
fender located by the battery.
Always use a fuse with the same
amperage capacity for replacement.
Cutting Blades
Shut the engine off and remove
ignition key before removing the cutting blade(s) for
using heavy gloves when grasping the blade.
for cracks or damage, especially if you strike a
foreign object. Replace immediately if damaged.