Filter
Top Products
8
Drive Clutch Control
The drive clutch control is located on the upper handle
assembly. Squeezing the drive clutch control against
the upper handle engages the rear wheels. Release the
drive clutch control to slow down or stop the wheel
drive. See Figure 8.
Throttle Control Lever (Not Shown)
The throttle control lever is located on the engine. It
controls the engine’s speed and stops the engine. See
separate engine manual packed with unit for details.
Engine Controls
See the separate engine manual for the location and
function of the controls on the engine.
Stopping Engine
• Move throttle control lever to STOP or OFF
position.
• Disconnect spark plug wire from spark plug and
ground against the engine.
SECTION 4: OPERATING YOUR CHIPPER SHREDDER VACUUM
WARNING: Read, understand, and follow
all instructions and warnings on the
machine and in this manual before
operating.
Always wear the safety glasses provided
with this machine during operation or
while performing any adjustments or
repairs. Thrown objects which ricochet
can cause serious injury to the eyes.
Gas And Oil Fill-Up
Service the engine with gasoline and oil as instructed in
the separate engine manual packed with your chipper
shredder vacuum. Read instructions carefully.
WARNING: Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine is hot or running. Extinguish
cigarettes, cigars, pipes, and other
sources of ignition.
Starting Engine
• Attach spark plug wire to spark plug. Make certain
the metal cap on the end of the spark plug is
fastened securely over the metal tip on the spark
plug.
• Make certain drive clutch control is in the
disengaged (released) position.
• Engines with choke lever:
Move choke lever on engine to CHOKE position. (A
warm engine may not require choking).
• Engines with primer:
Prime engine as instructed in separate engine
manual.
• The throttle control lever is located on the engine.
Move engine throttle control lever to FAST or
START position.
• Place one foot on the left rear wheel to prevent the
unit from skidding while starting.
• Grasp starter handle and pull rope out slowly until
engine reaches start of compression cycle (rope
will pull slightly harder at this point).
NOTE: A noise will be heard when at the start of the
compression cycle. This noise should be expected until
the impeller reaches full speed.
• Pull rope with a rapid, continuous, full arm stroke.
Keep a firm grip on starter handle. Let rope rewind
slowly.
• Repeat the previous steps until engine fires. When
engine starts, move choke control (if equipped)
gradually to RUN position.
WARNING: Keep bystanders, helpers,
pets, and children at least 75 feet from the
machine before starting and while
operating. Do not operate this machine
unless the discharge chute and bag have
been properly installed and secured to the
machine.
To Empty Bag
The bag is designed to be emptied without being
removed from unit. Open the large zipper in the rear of
the bag to empty the contents. If bag is removed for any
reason, follow the instructions for attaching the bag in
the ASSEMBLY section. Be certain the zipper is closed
completely when operating the unit.
To Engage Drive
To engage the wheel drive, hold the drive clutch control
against the upper handle. Releasing the drive clutch
control stops the rear wheels from driving. Release the
drive clutch control to slow down when negotiating an
obstacle, making a turn, or stopping. Engage control
slowly to prevent the front wheels from lifting up.
Using the Chipper Shredder Vacuum
Place both hands on top of upper handle to push unit
over yard waste. Yard waste such as leaves and pine
needles can be vacuumed up through the nozzle for