Filter
Top Products
26
OPERATORS VIEW
777S32066
FRONT TOP OF AUGER HOUSING
CUT FOOT PICTORIAL FACING
AWAY FROM OPERATOR
KEEP AWAY FROM ROTATING IMPELLER
AND AUGER. CONTACT WITH IMPELLER OR
AUGER CAN AMPUTATE HANDS AND FEET
.
USE CLEAN-OUT TOOL TO UNCLOG
DISCHARGE CHUTE.
DISENGAGE CLUTCH LEVERS, STOP ENGINE,
AND REMAIN BEHIND HANDLES UNTIL ALL
MOVING PARTS HAVE STOPPED BEFORE
UNCLOGGING OR SERVICING MACHINE.
TO AVOID THROWN OBJECTS INJURIES,
NEVER DIRECT DISCHARGE AT BYSTANDERS.
USE EXTRA CAUTION WHEN OPERATING ON
GRAVEL SURFACES.
READ OPERATOR'S MANUAL.
1.
2.
3.
4.
5.
DANGER
CLEAN-OUT TOOL
DANGER
AVOID INJURY FROM
ROTATING AUGER -
KEEP HANDS, FEET
AND CLOTHING AWAY.
REF. 777S32236
MOLD-IN GRAPHIC
DANGER
NEVER PUT HAND IN CHUTE. CONTACT WITH
ROTATING PARTS CAN AMPUTATE FINGERS
AND HANDS.
SHUT OFF ENGINE AND WAIT UNTIL ALL
MOVING PARTS HAVE STOPPED BEFORE
UNCLOGGING.
USE CLEAN-OUT TOOL OR WOODEN
STICK TO
UNCLOG DISCHARGE CHUTE.
S
T
O
P
I22376
AC
CHOKE
THROTTLE
OFF
IGNITION
KEY
REMOVE TO
STOP
FULLY
INSERT
TO RUN
FULL
(ON)
S
T
OP
777I22376
PLACE ABOVE IGNITION
CUT-OUT
777D08455
777D08376
777I22343
777I22338
777I22375
TOP EDGE OF SHROUD
FACING OPERATOR
ENGINE CONTROLS
CHUTE DIRECTIONAL CONTROL
1.)
INSERT IGNITION KEY AND SNAP IN
PLACE.
2.)
SET CHOKE AND THROTTLE TO FULL (ON)
POSITION. PUSH PRIMER BUTTON 3x.
3.)
ROPE START:
PULL SLOWLY UNTIL HARDER TO PULL,
THEN PULL RAPIDLY TO START. REPEAT
PRIMING IF NEEDED.
ELECTRIC START:
DO NOT USE IN RAIN. CONNECT POWER
CORD AND PUSH ST
ARTER BUTTON.
REPEAT PRIMING IF NEEDED.
4.)
MOVE CHOKE SLOWLY TO OFF POSITION.
5.)
TO STOP ENGINE: MOVE THROTTLE TO
STOP POSITION.
STARTING INSTRUCTIONS:
CHUTE TILT DOWN
CHUTE TILT UP
PUSH BUTTON
CHUTE ROTATE
LEFT
PUSH BUTTON
CHUTE ROTATE
RIGHT
RIGHT TURN CONTROL
LEFT TURN
TRIGGER CONTROL
RIGHT TURN
TRIGGER CONTROL
DRIVE CONTROL
SHEAR PIN
STORAGE
GO GO
DRIVE
CONTROL
AUGER
CONTROL
?
777I22378
DRIVE
AUGER
LOCK
777D03165
On each handle
grip
Safety & Decorative Labels