Filter
Top Products
Groundsmaster 4500--D/4700--DCutting Decks Page 8 -- 6
Adjustments
CAUTION
Never install or work on the cutting decks or lift
arms with the engine running. Always stop en-
gine and remove key from ignition switch first.
See the Cutting Deck Operator’s Manual for adjustment
procedures for cutting decks on the G roundsmaster
4500--D and Groundsmaster 4700--D.
Blade Stopping Time
Thebladesofthecuttingdecksaretocometoacom-
plete stop in approximately five (5) seconds after the
PTO is disengaged.
NOTE: Make sure the decks are lowered onto a clean
section of turf or hard surface to avoid dust and debris.
To verify this stopping time, have a second person stand
back from the machine at least twenty (20) feet and
watch the blade on one of the cutting decks. Have the
machine operator disengage the PTO and record the
timeittakesforthecuttingdeckbladetocometoacom-
plete stop. If this time is greater than seven (7) seconds,
the deck control manifold braking valve (RV) may need
adjustment.