Filter
Top Products
Groundsmaster 4500--D/4700--D Page 7 -- 9 Chassis
Disassembly (Fig. 8)
1. Park machine on a level surface, lower cutting
decks, stop engine and engage parking brake. Remove
key from ignition switch.
2. Remove two (2) flange head screws (item 8) and
then cover plate (item 7) from outside of console arm.
Locate and retrieve two (2) flange spacers (item 36).
3. At front of console arm, remove screw (item 5) and
lock nut (item 6) that secure console arm covers to each
other.
4. Remove five (5) washer head screws (item 4) that
secure each cover to console arm panel.
5. Remove console arm covers from machine. As LH
cover (item 2) is removed from console arm, unplug wire
harness connector from headlight switch.
6. Remove electrical components from console arm as
needed using Figure 8 as a guide.
7. If necessary, remove console panel and supports
from machine using Figures 8 and 9 as guides.
Assembly (Fig. 8)
1. Install all removed electrical and console arm com-
ponents using Figure 8 and 9 as guides.
2. Position covers to console arm. As LH cover (item 2)
is placed, plug wire harness connector to headlight
switch.
3. Secure each cover to console arm with five (5) wash-
er head screws (item 4). Install screw (item 5) and lock
nut (item 6) to secure covers at front of console arm.
4. Position cover plate and flange spacers to outside of
console arm. Secure with two (2) flange head screws.
1. Flat washer
2. Seat belt buckle
3. Coupling nut
4. Spacer
5. Carriage screw (5 u sed)
6. Cap s crew
7. Arm support
8. Cap screw
9. Flange nut
10. Support channel
11. Support bracket
12. Cap screw
Figure 9
2
3
6
7
5
4
8
9
10
1
11
12
9
5
Chassis