Filter
Top Products
13
3. GETTING STARTED
This section addresses the procedures for unpacking the instrument and inspecting for
damage, and introduces the instrument layout, then presents the procedures for getting
started: making electrical and pneumatic connections, and conducting an initial
calibration check. Please see the Model T200 Operation Manual for more information.
3.1 UNPACKING
CAUTION – GENERAL SAFETY HAZARD
To avoid personal injury, always use two persons to lift and carry the Model T265.
ATTENTION
COULD DAMAGE INSTRUMENT AND VOID WARRANTY
Printed Circuit Assemblies (PCAs) are sensitive to electro-static
discharges too small to be felt by the human nervous system. Failure
to use ESD protection when working with electronic assemblies will
void the instrument warranty
See A Primer on Electro-Static Discharge in the accompanying Model
T200 manual for more information on preventing ESD damage.
CAUTION - ELECTRICAL SHOCK HAZARD
Never disconnect PCAs, wiring harnesses or electronic subassemblies while
analyzer is under power.
07337B DCN6324