Filter
Top Products
Your pool is equipped with (3) three special warning ledges. The
(1) one ledge with a large warning on top is to be installed by the
entry point into the pool and is not to be obstructed by any object
such as your ladder. The (2) two ledges with the warning on the
inside are to be placed opposite the entry point into the pool with the
warning facing the entry point.
THESE WARNINGS ARE NOT TO BE REMOVED
UNDER ANY CIRCUMSTANCES
Place ledges over the wall with each end resting on a top plate. Using the above
chart as a guide align the set of holes in the top plate as shown in the above drawing
for your size pool with the holes in the ledge and insert the No.12x1/2" Sheet Metal
Screw through the ledge and into the top plate. The actual screw holes that are used
does not affect the integrity of the pool. You may use the set of holes that line up best!
The ledge screws should not be tightened until all the ledges are in place and
the pool has been filled with water.
NOTE: Your pools top ledge was not designed to be a walk around.
Caution everyone who uses your pool NOT TO WALK OR SIT ON THE LEDGE!
If your pool is equipped with feature tape it is best to apply it to the ledges at this time.
23
INSTALLING LEDGES
AND PLACEMENT OF WARNING LABELS
22
No. 12 x 1/2”
Sheet Metal
Screw
WARNING
LEDGE
PLACEMENT
ENTRY POINT
Refer to the "Construction Close-ups" at the
beginning of these Instructions as indicated below:
C
D
E
E
D
C
B
B
A
A
SCREW HOLE LOCATION GUIDE
12x8 15x1016x1018x12 24x12 24x1530x15 33x18
OVAL OVAL OVAL OVAL OVAL OVAL OVAL OVAL
FIG. A & E
(6" Ledge/ 6" Vertical)
A & E A & E A & E A & E A & E A & E A & E A & E
FIG. C, D & F
(6" Ext. & 7" Ledge/ 6" Box Vertical)
A & C A & C A & C A & C A & C A & C A & C A & D
FIG. B
(9" Ledge/ 8" Box Vertical)
A & B A & B A & B A & C A & C A & C A & C A & C