Filter
Top Products
Start assembling the supports by placing two T-Plates inside the Bottom Support and insert
and tighten the 3/8” - 16 x 1” hex head bolts and 3/8” - 16 hex nuts as shown on image A.
10
T-PLATES & VERTICAL PLATES ASSEMBLY
5
END SUPPORT POST ASSEMBLY
6
End Support Posts
(4 per pool)
A
C
B
E
D
Attach the
Vertical Plate
onto the Bottom
Support using two
#12 x 1/2” sheet
metal screws as shown
on image B.
Insert the End Support
Post between the
T-Plates and through
the hole in the Vertical
Plate (image C).
Then insert the Support
Post over the End
Support Post (image D).
The open side of the
posts must face the
inside of the pool.
Insert the 3/8” - 16 x 1”
hex head bolts and
3/8” - 16 nuts and
tighten as shown on
image E.
Inside
of Pool
Outside
of Pool