Filter
Top Products
26
11.7 Panel displays
ICE
Freeze Protection - A potential freeze condition has
been detected. No action is required. Main pump
will operate to circulate warm water through the
plumbing until the spa is out of danger.
11.8 Panel Displays - - -
The safety “Watchdog” software has been triggered
and the spa is deactivated. A problem has been
detected which could cause damage to the spa or its
components. Contact your authorized dealer.
12.0 Troubleshooting Procedures
In the event your Portofino spa is not working the way it should,
please first review all the installation and operating instructions in
this manual and check the message on the panel display. If you are
still not satisfied it is working properly, please follow the appropriate
troubleshooting instructions.
Note: If any of the supply cords to the
accessories are damaged, they must be replaced by authorized
service personal.
12.1 No Components Operate (e.g. Pump, Light)
Check the following:
1. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Call your authorized dealer.
12.2 Pump Does Not Operate But Light Does
Press the JETS button:
1. If no water movement is detected, make sure power is going to
the spa and check the water level. If it does not solve the prob-
lem, contact your authorized Portofino dealer.
2. The main pump operates but no water flows to jets. Pump may
not be properly primed. This can happen after the spa is drained
and refilled. Press the JETS Button several times, never leaving
the motor on for more than 5 to 10 seconds at-a-time. Turn
power off and let the air out by loosening the cap on the diverter
and/or remove the filter.
Refer to section 7.3 (page 10).
Make