Filter
Top Products
9.2 Standard Skimming/Heating Mode
In this mode, 2-stage water filtration is achieved by activating pump 1 for
the programmed skimming/heating cycle. Water temperature is regulated
by the set temperature, 24-hour circulation pump, and heater which turns
on as needed. After the programmed set temperature is reached, the
heater turns off and the circulation pump continues to operate 24-hours to
filter and clean your spa through the MicroClean filter cartridge (unless pro-
grammed otherwise).
9.3 Economy Skimming/Heating Mode
In this mode, the pr
ogr
ammed skimming/heating cycle is disabled.
Water
temperature is regulated by the set temperature and 24-hour circulation
pump. The circulation pump also filters and cleans the water by drawing it
through the MicroClean filter cartridge.
9.4 Selecting Standard or Economy Skimming/Heating Mode
Press the MODE button to select either “Standard” or “Economy”
skimming/heating mode (Figure-E, Page 13). The control panel’s indicator
on the right side of the LCD changes to indicate which mode is selected.
When an automatic skimming/heating cycle activates, the LCD screen
displays the following message:
FILTER
CYCLE ON
9.5 Clean-Up Cycle
The clean-up cycle is once per day in both Standard and Economy mode
at 12:00 PM (noon) for two minutes. This is not user programmable. Pump
#2 and blower activate for one minute to circulate any water in the plumb-
ing. After 1 minute they both go off and Pump #1 runs for 1 minute. If
the skimming/heating cycle is also set at 12:00 PM (noon), pump #1 will
continue to run for the duration of the cycle.
Page 24
ENGLISH