Filter
Top Products
8.0 Operating Instructions
Your Sundance hot tub has a touch-sensitive control panel, massage selector
valves and air control knobs located on the top rim of the hot tub (Figure-F,
page 14). These controls let you operate many of the special functions of your
Sundance hot tub. By familiarizing yourself with the following information, you
will be able to gain the full benefit afforded by the various functions of your
hot tub.
8.1 View
Pressing this sensor pad inverts the main four-digit display on the
Command Center’s LCD screen to allow easy reading from either
inside or outside the hot tub.
8.2 Light
The LIGHT sensor pad activates both the underwater light and the
light symbol on the LCD screen when pressed To reduce the
brightness of the light, press the sensor pad again. A third press
will result in an even lower level of illumination. A fourth press turns the light
off. If left on, the light will automatically turn off after one hour.
There are two colored lenses included with your hot tub which may be placed
over the light lens inside the hot tub. To remove a lens, pull straight out. To
install a lens, align tabs and push straight in. Your hot tub comes with a clear
lens installed.
The optional SunGlow
TM
Multi-Colored LED Light Kit (#6560-240) can
retrofit the factory installed spa light. This option offers 7 light colors and a
unique random mode for enhanced spa enjoyment. Consult your Sundance
Dealer for additional information.
8.3 Air Injection
When the AIR sensor pad is pressed, the air blower forces air
through the injectors located in the seats and footwell. The bub-
bles symbol above the sensor pad appears on the LCD display
whenever the air blower is on. An electronic timer automatically turns the air
blower off 20 minutes after it was turned on. Note: The air blower automat-
ically activates for 1 minute at the start of the clean-up cycle at 12:00 (Noon).
This clears the lines of the air injector system to help ensure that all water is
exposed to sanitizer. This cycle is non-programmable.
8.4 Jets 1 - The sensor pad labeled JETS 1 controls the main
jets pump #1. Pressing this sensor turns pump #1 on and off.
Page 12
ENGLISH