16 ► DS11 User Manual
REPLACING THE CHAIN BREAKER
PUNCH
If the chain breaker punch (P/N 22801) becomes worn
or damaged, use the following procedures for replace-
ment.
1. Remove the punch by loosening the set screw (Fig-
ure 14).
Figure 14. Removing the Punch
2. Insert a new punch into the holder and push it up
until it is fully seated (Figure 15). Secure the punch
to the chain breaker holder by fully tightening the
set screw.
Figure 15. Replacing the Punch
SPINNING RIVETS
The following procedures explain how to spin rivets us-
ing Stanley’s bench-mounted rivet spinner (P/N 20857)
to assembly the chain.
1. Mount the rivet spinner ush with the side or front of
a at, clean work surface (Figure 16).
Figure 16. Rivet Spinner Mounting
2. Lay the chain across the plastic chain supports and
then rotate the supports so the rivet head is cen-
tered between the take-up handle pocket and the
spinner anvil (Figure 17).
Figure 17. Positioning the Chain
3. Turn the take-up handle until the chain is tight
against the spinner anvil (Figure 18).
Take-up
Handle
Rivet Spinner
Crank
Figure 18. Securing the Chain
4. Turn the rivet spinner crank a few times to center the
rivet hub in the spinner anvil (Figure 19).
MAINTENANCE & ADJUSTMENTS