Filter
Top Products
3
STANLEY is a registered trademark of The Stanley Works or its affiliates and are used under license by GXi Outdoor Power LLC.
No part of this publication can be printed or copied without written permission.
Rev2.5-15-12
Recoil Starter
The starter handle is located on the
engine. Pull the starter handle to start
engine.
Leaf Funnel
Use the Leaf funnel to feed leaves
and branches no larger than 1/4”
only.
Limb Chute
Use the Limb chute to feed longer
and/or thicker pieces of yard waste
into the impeller for chipping.
Depending on the model #, the
chipper/shredder can cut up to a
2.25” or 3” diameter piece of wood.
Discharge Chute
Chipped materials are discharged
through this opening.
Fuel Tank
Use regular unleaded fuel. Always leave
about 1” of air gap at the top of the tank
for fuel expansion to prevent seepage or
spills.
Hardware Bag (Not shown)
This bag contains the owner’s manual, assembly
hardware, tools, safety glasses and oil fill funnel
On/Off Switch
Set this to On before using recoil starter.
Set switch to Off to turn off engine.
Choke Lever
Move the choke lever to the CHOKE
position to prepare a cold engine for
starting.
Fuel Valve
Use the fuel valve to turn fuel on and off
to engine.
If you are missing any parts, please complete the form on the next page and fax it to us at: 919-550-3277.
Serial #:
Stamped on engine block between funnel
and engine
Component Identification