Filter
Top Products
13
STANLEY is a registered trademark of The Stanley Works or its affiliates and are used under license by GXi Outdoor Power LLC.
No part of this publication can be printed or copied without written permission.
Rev2.5-15-12
Item
Before each
use
20 hrs or
every 3
months
50 hrs or eve-
ry 3 months
100 hrs or eve-
ry 6 months
300 hrs or
every 1 year
Check for loose fasteners (check) X
Engine Oil (Check) X
Engine Oil (Change) X
Air Cleaner (Check) X
Air Cleaner Wash X
Fuel filter Cup (Clean) X
Spark Plug (Clean) X
Spark Plug (Change) X
Check Chipper Blade X
Fuel Tank and Filter (Clean) X
Maintenance Schedule
Always stop engine, disconnect spark plug, and ground
against engine before cleaning, lubricating or doing any
kind of maintenance on your machine.
Maintenance and Storage
1. Never tamper with safety devices. Check their proper operation
regularly.
2. Check bolts and screws for proper tightness at frequent intervals
to keep the machine in safe working condition. Also, visually
inspect machine for any damage and repair, if needed.
3. Before cleaning, repairing, or inspecting, stop the engine and
make certain the impeller and all moving parts have stopped.
Disconnect the spark plug wire and ground it against the engine to
prevent unintended starting.
4. Do not change the engine governor settings or overspeed the
engine. The governor controls the maximum safe operating speed
of the engine.
5. Maintain or replace safety and instruction labels, as necessary.
6. Follow this manual for safe loading, unloading, transporting, and
storage of this machine.
WARNING
7. Never store the machine or fuel container inside where there is
an open flame, spark or pilot light such as a water heater,
furnace, clothes dryer, etc.
8. Always refer to the operator’s manual for proper instructions on
off-season storage.
9. If the fuel tank has to be drained, do this outdoors.
10. Observe proper disposal laws and regulations for gas, oil, etc. to
protect the environment.
If the Chipper Becomes Clogged:
If the discharge area becomes clogged:
Stop the engine. Disconnect spark plug wire from spark plug and
ground against the engine.
Remove leaf funnel
Reach in and clear the debris causing the blockage. Reinstall the
funnel and the clean out access hatch.
Connect the spark plug wire and restart.
NOTE: If the blockage is severe, the hammer screen within the
discharge chute can be removed as well, providing greater access. To
accomplish this, remove the discharge chute and the flail screen out of
the discharge chute.
Maintenance and Storage