Filter
Top Products
11
STANLEY is a registered trademark of The Stanley Works or its affiliates and are used under license by GXi Outdoor Power LLC.
No part of this publication can be printed or copied without written permission.
Rev2.5-15-12
NOTE: The chipper/shredder operates most efficiently at
the factory set engine speed of 3600 RPM. The speed is
controlled by the governor, and the throttle setting should
not be adjusted. Do not attempt to adjust the speed of the
engine.
Emission Control System Information
The U.S. and California Clean Air Acts
EPA and California regulations require all manufacturers to furnish
written instructions describing the operation and maintenance of
emission control systems. The following instructions and procedures
must be followed in order to keep the emissions from your DEK engine
within the emission standards.
The emission control systems on your DEK engine were designed, built,
and certified to conform with EPA and California emission regulations.
Maintenance, replacement, or repair of the emission control devices
and systems may be performed by any engine repair provider, using
parts that are ‘‘certified’’ to EPA standards.
We recommend the use of
genuine DEK parts whenever you have maintenance done. These
original-design replacement parts are manufactured to the same
standards as the original parts, so you can be confident of their
performance.
The use of aftermarket replacement parts, not of the original design
and quality, may impair the effectiveness of your emission control
system. A manufacturer of an aftermarket part assumes the
responsibility that the part will not adversely affect emission control
performance and must certify that use of the part will comply with
emission regulations.
In the State of California a spark arrestor is required by law. Other
states may have similar laws. Federal laws apply on all federal lands. If
you equip the muffler with a spark arrestor, it must be maintained in
effective working order.
Carbon Monoxide Gas
Exhaust contains poisonous carbon monoxide, a colorless and
odorless gas. Breathing exhaust can cause loss of consciousness and
may lead to death. To keep exhaust gas from accumulating, DO NOT
use this product in a garage, basement, crawlspace, enclosed shed, or
any other area without adequate ventilation. DO NOT use this
equipment near ventilation ducts or open windows that may allow
exhaust gasses to enter your home or business. ONLY operate this
product outdoors.
The engine exhaust from this product and other components contain
chemicals known to the State of California to cause cancer, birth
defects or other reproductive harm.
Fire and Burn Hazards
The exhaust system gets hot enough to ignite some materials.
Keep the power equipment at least 3 feet (1 meter) away from
buildings and other equipment during operation.
Do not enclose this product in any structure.
Do not smoke when refueling.
Keep flammable materials away.
The muffler becomes very hot during operation and remains hot
for a while after stopping the engine. Be careful not to touch
the muffler while it is hot.
Let the engine cool before storing.
Refuel in a well ventilated area with the engine stopped.
Fuel vapors are extremely flammable and may ignite after the
engine has started. Make sure that any spilled fuel has been
wiped up before starting the engine.
WARNING
WARNING
Important Engine Information