Filter
Top Products
21
Regular Maintenance
Size
PSI bar
6-8 ,41-,55
12-15 ,8-1
20 x 10.0-8
15 x 6.00-6
Figure 15. Tire Pressure
CHECK TIRE PRESSURES
Service Interval: Every 25 Hours
Tire Pressure should be checked periodically, and main-
tained at the levels shown in the chart. Note that these
pressures may differ slightly from the “Max Inflation”
stamped on the side-wall of the tires. The pressures
shown provide proper traction, improve cut quality, and
extend tire life.
TRANSMISSION MAINTENANCE
K46 Maintenance
The K46 is a sealed unit and does not require regular
maintenance. If the transmission lacks drive or is exces-
sively noisy, it may need to be purged. See TRANSMIS-
SION PURGING in the Troubleshooting, Adjustments, &
Service Section.
BATTERY MAINTENANCE
Cleaning the Battery and Cables
Service Interval: Every 100 Hours
1. Disconnect the cables from the battery, negative
cable first (A, Figure 16).
2. Remove the battery hold-down (C) and battery.
3. Clean the battery compartment with a solution of bak-
ing soda and water.
4. Clean the battery terminals and cable ends with a
wire brush and battery terminal cleaner until shiny.
5. Reinstall the battery in the battery compartment, and
secure with the battery hold-down (C).
6. Reattach the battery cables, positive cable first (B).
7. Coat the cable ends and battery terminals with petro-
leum jelly or non-conducting grease.
WARNING
When removing or installing battery cables,
disconnect the negative cable FIRST and reconnect
it LAST. If not done in this order, the positive
terminal can be shorted to the frame by a tool.
Figure 16. Battery
A. Negative Cable
B. Positive Cable & Cover
C. Rubber Hold-Down Strap
A
C
B