Filter
Top Products
PTO Switch
The PTO (Power Take-Off) switch engages and disen-
gages attachments that use the PTO. To engage the
PTO, pull UP on the switch. Push DOWN to disengage.
Note that the operator must be seated firmly in the trac-
tor seat for the PTO to function.
Ignition Switch
The ignition switch starts and stops the engine, it has
three positions:
OFF Stops the engine and shuts off the
electrical system.
RUN Allows the engine to run and powers the
electrical system.
START Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN posi-
tion with the engine stopped–this drains the battery.
Ground Speed Pedals
The tractor’s forward ground speed is controlled by the
forward ground speed control pedal. The tractor’s
reverse ground speed is controlled by the reverse
ground speed control pedal.
Depressing either pedal will increase ground speed.
Note that the further down the pedal is depressed, the
faster the tractor will travel.
Mower Height of Cut Adjustment
The cutting height adjustment knob controls the mower
cutting height. The cutting height is infinitely adjustable
between 1” and 3-3/4” (2.5cm-9.5cm).
Cutting Height Fine Tuning Adjustment
The cutting height fine tuning adjustment is used to set
the mower cutting height between two of the preset cut-
ting positions.
Attachment Lift Control Lever
When using the mower deck, lift the deck off the ground
while transporting to and from the job site. DO NOT cut
with the mower in the raised, transport position.
The attachment lift control lever raises and lowers
attachments that utilize the tractor’s manual lift linkage.
Pushing the lever forward lowers the attachment while
pulling the lever back raises the attachment. You must
pull back slightly on the lever and depress the release
button to change lift positions. Be sure the lever is fully
forward when mowing.
11
Features & Controls
Catcher Removal Lock
After depressing the catcher dump lock pedal, pull this
knob forward to release the catcher for removal.
Cruise Control (Optional)
The cruise control is used to lock the ground speed con-
trol in forward. Move the lever forward until the desired
ground speed is reached. To disengage the cruise con-
trol move the lever back. In the event you need to stop
quickly, depressing the brake pedal will also return the
cruise control to neutral.
Seat Adjustment Lever
The seat can be adjusted forward and back. Move the
lever, position the seat as desired, and release the lever
to lock the seat into position.
Transmission Release Valve Lever
The transmission release valve lever deactivates the
transmission so that the tractor can be pushed by hand.
See PUSHING THE TRACTOR BY HAND for opera-
tional information.
Catcher-Full Alarm
The “catcher full” alarm sounds when the grass catcher
has been filled with cut grass. When the alarm sounds,
disengage the PTO, travel to the area in which you
desire to dump the grass, then empty the catcher. Note:
When using the unit for leaf collection, the alarm may not
be activated by dry leaves.
Fuel Tank / Fuel Gauge
The fuel gage indicates the amount of fuel in the fuel
tank. To add fuel, remove the filler cap. Be sure to
leave room for heat expansion.
Parking Brake
The parking brake knob is used to lock the parking brake
when the tractor is stopped. Fully depressing the brake
pedal and pulling up on the knob engages the parking
brake. Refer to page 12 for a full explanation of parking
brake functions.
Catcher Dump Lock Pedal
The catcher dump lock pedal unlocks the catcher so that
it can be opened to dump out collected grass.