Filter
Top Products
23
Installation
ES GB
Install Collector Mount Plate
(S150X & S200X Series)
1. Remove the carb. shield plate from top of the rear
bumper.
2. Install the collector mount plate (A, Figure 40) and
mount tabs (B) on to the bumper. Install the 3/8-
16 x 1-1/4” bolts (C) and 3/8” SAE washers (F)
through the mount tabs and loosely secure with
the 3/8-16 nylock flange nuts (E).
3. Install the 3/8-16 x 1” bolts (D) and 3/8” SAE
washers (F) through the bottom mounting holes
and loosely secure with the 3/8-16 nylock flange
nuts (E).
4. Tighten the bottom mounting bolts securely.
5. Temporarily install the collector mount posts (A,
Figure 41) into the collector plate and install the
hitch pins (B). This will insure that the holes are
properly aligned for easy installation and removal.
6. Tighten the top mounting bolts (C, Figure 37)
securely and remove the hitch pins and mount
posts.
A
B
Figure 40. Install Collector Mount Plate
A. Mount Plate
B. Mount Tab
C. 3/8-16 x 1-1/4” Bolt
D. 3/8-16 x 1” Bolt
E. 3/8-16 Nylock Flange Nut
F. 3/8” SAE Washers
B
Figure 41. Install Mount Posts & Hitch Pins
A. Mount Post
B. Hitch Pin
A
B
E
E
C
F
F
D
D
Collector Installation