Filter
Top Products
14 www.ferrisindustries.com
Installation
Mower Deck Preparation
IS4500Z Series:
1. Using a 1/2” breaker bar, place the square end in
the square hole located near the end of the idler
arm (A, Figures 21). Carefully rotate the breaker
bar clockwise, which will relieve the tension on the
belt exerted from the idler arm.
2. Remove the belt from the trim side spindle pulley
(B).
3. Carefully release the tension on the breaker bar.
4. Remove the belt from the right-hand (discharge
side) spindle pulley.
Figure 21. Spindle Drive Belt Removal
A. Idler Arm
B. Trim Side Spindle Pulley
B
A
A
B
B
Figure 20. Mower PTO Belt
A. Idler Arm
B. Stationary Idler Pulley
S200X Series:
1. Using a 1/2” breaker bar, place the square end in
the square hole located in the end of the idler arm
(A, Figures 20). Carefully rotate the breaker bar
counter-clockwise, which will relieve the tension
on the belt exerted from the idler arm.
2. Slide the drive belt over the edge of the stationary
idler pulley (B). Carefully release the tension on
the breaker bar. Remove the belt from the right-
hand (discharge side) spindle pulley.